Aironet AP3500-E Uživatelská příručka stáhnout pdf (Strana 15)

Installation

2- 1

Installation

This section describes the procedures for installing the

Aironet Access Point.

Installing the Antennas

The AP3500-E comes with two antennas.

1. With the unit powered off, attach both antennas to the

antenna connectors.

NOTE: Do not over-tighten; finger tight is sufficient. Position

the antennas vertically for best omni-directional signal

reception.

2. If you are using the Aironet Access Point with a remote

antenna, connect the coaxial cable to the antenna

connector. Only use antennas and cables supplied by

Aironet Wireless Communications.

NOTE: Due to FCC and DOC Regulations, the antenna

connectors on the Aironet Access Point are of reverse

polarity to the standard TNC connectors.

10Base2

10Base5

10BaseT

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Žádné komentáře

Aironet AP3500-E Uživatelská příručka Strana 15